PDMS tutorial from Said: Creating beam using start and end of existing beams

Creating beam using start and end of existing beams.

Mostly you need to connect new beam to ends existing beams.

From menu Create Sections Straight. Click Ok. Click on

-Define Start/end explicitly.

In this case toolbar Positioning will be activated. You can select Element or just select left beam.

You will see word Start.

This tutorial created by Said Babanli (Azerbaijan). (Created 02.10.08) Please send comments or additional to mail: sbabanli@gmail.com

PDMS tutorial from Said: Creating beam using start and end of existing beams

Click Ok. Click on

again. You will be prompted to select end of new beam.

Select right beam.

Click OK.

This tutorial created by Said Babanli (Azerbaijan). (Created 02.10.08) Please send comments or additional to mail: sbabanli@gmail.com

PDMS tutorial from Said: Creating beam using start and end of existing beams

This tutorial created by Said Babanli (Azerbaijan). (Created 02.10.08) Please send comments or additional to mail: sbabanli@gmail.com